VARNISHES
Finishfit WBC Gloss FCM 1859
Dispersion varnish
Finishfit FCM 1859
Field of application
Finishfit gloss 1859 LM (=LM: suitable for LM packaging printing) is recommended for inline coating in sheetfed offset/coating unit (chambered doctor blade). The varnish is also suitable for off-line coating with dry, conventional inks. In both cases, it can be used over a large area without water.
Finishfit gloss 1859 LM is suitable for the use on the side of a print product facing away from the food stuff, which should meet the requirements of Regulation (EC) 1935/2004, Art. 3.
Finishfit gloss 1859 LM has been specially developed for maximum machine speed with minimum transfer times between printing and finishing.
Properties
- Suitable for indirect food contact
- Heat resistant 170 - 180 °C (338 – 356 °F)
- Drying by IR and hot air
- Excellent rub resistance
- Very good wet-blocking resistance
- Fast drying
- Applicable on both sides
- Suitable for long and short delivery
- Can be used on paper and cardboard
- Standard viscosity 35 - 50 sec., measured at 20 °C (68 °F), DIN 4mm viscosity cup
Application
- Stir well before using
- The properties depend on the substrate and the application quantity
- Powder spraying if required
Additives
- For cleaning flexo engraved rollers we recommend Cleanfit Anilox 2259
Storage
- Protect from frost, heat and direct sun light
- Storage only in original packaging at 10 – 30 °C (50 – 86 °F)
- Unopened and correctly stored, the Finishfit gloss 1859 LM has a shelf life of 12 months from delivery date
Standard packaging
- 25 kg can
- 220 kg drum
- 1.050 kg container / IBC
Note: This technical description is intended to inform and advise you. It corresponds to our current state of knowledge. However, since the specific application depends on a number of factors over which we have no influence, no guarantee and liability for the pressure failure can be derived.