VARNISH
Finishfit® WBC Barrier FCM DFC 2169
Finishfit DFC 2169
Finishfit® WBC Barrier FCM DFC 2169 (DFC = direct food contact, suitable for direct food con-tact) is recommended for inline coating in the sheet-fed offset/coating unit (chambered doctor blade). The coating is also suitable for offline coating with dry, conventional inks. In both cases it can be applied without water.
Finishfit® WBC Barrier FCM DFC 2169 is suitable for use on the non-food contact side of a printed product that is intended to meet the requirements of Regulation (EC) No. 1935/2004, Art. 3. In addition, the Finishfit® WBC Barrier FCM DFC 2169 can be used in direct food con-tact. This has been confirmed by an independent analysis institute (SQTS) using a practical print sample as an example.
Finishfit® WBC Barrier FCM DFC 2169 has been specially developed for maximum press speed with minimum transfer times between printing and finishing.
Properties
- Suitable for direct food contact
- Barrier against grease and water
- Good drying
- Wet block resistant
- Two layers of varnish are recommended to increase the barrier properties
- Minimum application quantity 6 – 8 g/m2
- Long delivery recommended
- Drying by IR and hot air
- Can be used on paper and cardboard
- Standard viscosity 50–70 sec., measured at 20 °C (68° F) DIN 4mm viscosity cup
Application
- Stir well before use
- The properties depend on the substrate and the application quantity
- Powder spraying if required
- Only use printing inks which are solvent, alkali and spirit resistant accrding to DIN ISO 2836
Additives
- For cleaning flexo engraved rollers we recommend Cleanfit Anilox 2259
Storage
- Protect from frost, heat and direct sunlight
- Storage only in original packaging at 10 – 30 °C (50 – 86° F)
- Unopened and correctly stored Finishfit® WBC Barrier FCM DFC 2169 has a shelf life of 12 months from date of delivery
Standard Packaging
- 25 kg can
- 125 kg drum
- 220 kg drum
- 1,050 kg container/ IBC